Persistence of endodontic methacrylate-based cement residues on dentin adhesive surface treated with different chemical removal protocols

The aim of this study was to evaluate the persistence of methacrylate-based cement residues on the dentin, after dentin surface cleaning with ethanol or acetone, with or without previous application of a dentin adhesive. Forty bovine crown fragments were obtained and the dentin surface was washed with 1.0 mL of 2.5% sodium hypochlorite (NaOCl), followed by 0.1 mL of 17% ethylenediaminetetraacetic acid application for 3 min, and final irrigation with 2.5% NaOCl. The specimens were air dried and resin-based cement was rubbed onto the dentine surface with a microbrush applicator. In 20 specimens, previously to cement, a dentin adhesive was applied in all surfaces. After 15 min, the surface was scrubbed with a cotton pellet and moistened with ethanol or acetone, compounding the following groups: G199.5% ethanol and G2acetone, without previous use of dentin adhesive; G399.5% ethanol and G4acetone, with previous use of dentin adhesive. The dentin surface was scrubbed until the cement residues could not be visually detected. Sections were then processed for scanning electron microscopy and evaluated at 500x magnification and scores were attributed to each image according to the area covered by residual sealer, and data were subjected to KruskalWallis at 5% significance. The lower residue presence was observed in G3 (P = 0.005). All surface presented cement residues when acetone was used as cleaning solution (P = 0.0005). The cleaning solutions were unable to completely remove the cement residues from both surfaces. The ethanol used after previous application of the dentin adhesive promoted the lower presence of residues.

Persistence of resinous cement residues in dentin treated with different chemical removal protocols

The aim of this study was to evaluate the persistence of resin cement residues after dentin surface cleaning with different alcohol-based solutions or an essential oil (eucalyptol). Forty bovine teeth were sectioned in order to expose pulp chamber dentin to be washed with 1.0 mL of 2.5% sodium hypochlorite (NaOCl), followed by 0.1 mL of 17% EDTA application for 3 min, and final irrigation with 2.5% NaOCl. The specimens were air dried and resin-based cement was rubbed onto the dentine surface with a microbrush applicator. After 15 min, the surface was scrubbed with a cotton pellet and moistened with different dentin cleaning solutions, compounding the following groups: G195% ethanol, G270% ethanol, G370% isopropyl alcohol, or G4eucalyptol. The dentin was scrubbed until the cement residues could not be visually detected. Sections were then processed for SEM and evaluated at x 500 magnification. Scores were attributed to each image according to the area covered by residual sealer, and data were subjected to KruskalWallis at 5% significance. Eucalyptol promoted the most adequate dentin cleaning, although no statistical difference was detected amongst the groups (P > 0.05), except between the eucalyptol and 70% ethanol groups (P < 0.05). All the evaluated dentin cleaning solutions were unable to completely remove the cement residues from the dentin surface. Microsc. Res. Tech., 2012. (C) 2012 Wiley Periodicals, Inc.

Phylogeography of endemic toads and post-Pliocene persistence of the Brazilian Atlantic Forest

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Population persistence in weakly-coupled sinks

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

How the interplay between individual spatial memory and landscape persistence can generate population distribution patterns

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Persistence Length, Mass Fractal, and Branching in the Aggregating of Vinyltriethoxysilane-Derived Organic/Silica Hybrids

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Photodegradation of sulfamethoxazole in various aqueous media: Persistence, toxicity and photoproducts assessment

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Rainfall intensity and Mepiquat Chloride persistence in cotton

Em parte das regiões onde se encontram as maiores áreas de algodão no Brasil atualmente, o índice pluviométrico está ao redor de 2.000 mm anuais, existindo risco de ocorrer lavagem do Cloreto de Mepiquat (CM) das folhas do algodoeiro antes de ser absorvido pelas plantas. O objetivo deste trabalho foi avaliar a lavagem do CM aplicado no algodoeiro por diferentes laminas de chuva simulada. Os tratamentos constaram de três doses do regulador à base de cloreto de mepiquat: 0, 15.0 e 30.0 g ha-1 e quatro lâminas de chuva simulada: 5, 10, 20 e 40 mm, mais um tratamento sem chuva. Foram utilizados vasos de 12 litros de capacidade e a cultivar Delta Opal. Os parâmetros avaliados foram: altura de plantas, número de ramos reprodutivos, massa de matéria seca, retenção de estruturas reprodutivas e área foliar. Quanto maior a intensidade de chuva ocorrida após a aplicação do regulador maior foi o comprometimento da ação do produto, que repercutiu em interferência no crescimento das plantas. Chuvas de 5.0 mm, ocorridas 90 minutos após a aplicação do cloreto de mepiquat, já causaram prejuízo na ação do produto no crescimento do algodoeiro, sendo o efeito maior com o aumento da quantidade de chuva simulada.

Persistence of some pesticides in peach fruit

The persistence of five pesticides (acephate, azinphos methyl, carbendazim, diazinon and dimethoate) in peach fruit was studied in real operating conditions. Pesticides showed different degradation rates. Diazinon was degraded with a half-life (t(1/2)) of 5.2 days, acephate, azinphos methyl and dimethoate with t(1/2) of ca 12 days and carbendazim with t(1/2) of 15.5 days. After the pre-harvest interval (PHI) all pesticide residues were within the limits established by Italian law.

Thiabendazole uptake and persistence in lemons following postharvest dips at 50 degrees C

Thiabendazole (TBZ) uptake and degradation rate in lemon fruits, following prestorage dipping at 50 degrees C in mixtures containing different amounts of fungicide, was compared with those measured after treatment at standard room temperature. TBZ residues were strictly dependent upon the amount of fungicide. Following 1,200 ppm TBZ dipping at 20 degrees C residue uptake in fruit was the same that would have been accumulated with ca. 150 ppm fungicide at 50 degrees C, a value that can be calculated due to the linear relationship between the residue in fruit after treatment and fungicide concentration TBZ residues showed great persistence during fruit storage: after 13 weeks at 8 degrees C and 1 week at 20 degrees C residues in fruit averaged ca. 70% of their initial values. In this study it was shown that it is possible to employ remarkably low amounts of TBZ (ca. 150 mg kg(-1)), when applied in combination with water at 50 degrees C, and keep the same residues of fruit treated at room temperature with high amounts of TBZ (1,200 mg kg(-1)).

Persistence of conidia of Entomophthora muscae in relation to age, temperature, and humidity

In this paper, the effect of age, humidity, and temperature on the conidial survival of Entomophthora muscae was evaluated. E. muscae was obtained from Musca domestica in a dairy in Itatiba (São Paulo, Brazil) and maintained in the laboratory by continuous passage through flies. Furthermore, the ability of conidia to infect flies at three temperatures (17, 21, and 27 degrees C), four ages of conidia (12, 72, 96, and 154 hours) and two humidities (100 and 60% RH) was evaluated. The temperature of 21 degrees C was the most favorable for the infection of house flies. Humidity was a cause of variation at 27 degrees C when the conidia were up to 12 hours old, but had no effect at lower temperatures. Conidia held at 100% RH and aged 72 hours caused no infection at 17 degrees C, but were infective at 21 degrees C. In the present study, conidia retained viability much longer than previously observed. Finally, the effect of humidity, temperature, and conidial age is discussed.

Persistence of insecticide residues in olives and olive oil

The decay rate of six insecticides (azinphos methyl, diazinon, dimethoate, methidathion, parathion methyl, and quinalphos) used to control Dacus oleae was studied. Degradation of pesticides showed pseudo-first-order kinetics with correlation coefficients ranging between -0.936 and -0.998 and half-lives between 4.3 days for dimethoate and 10.5 days for methidathion. Residues in olive oil were greater than on olives, with a maximum concentration factor of 7. Dimethoate was the only pesticide with lower residues in the oil than on the fruits. Olive washing affects pesticide residues ranging from no reduction to a 45% decrease. During 8 months of storage of the olive oil, diazinon, dimethoate, parathion methyl, and quinalphos did not show any remarkable difference, while methidathion and azinphos methyl showed a moderate decrease.

Persistence and effectiveness of pyrethroids in plastic strips against Varroa jacobsoni (Acari : Varroidae) and mite resistance in a mediterranean area

An apiary trial was conducted in 1997 in Sardinia, Italy, to verify the effectiveness of fluvalinate in polyvinyl chloride strips and flumethrin in polyethylene strips against Varroa jacobsoni Oudemans. Two indices to evaluate the efficacy of the treatments were adopted: percentage change in mite infestation of worker-sealed brood cells considering only treated hives and percentage change in mite mortality, and the natural variation in mite populations recorded in control hives during the trial. All acaricide treatments reduced the level of mite infestation of both sealed brood and adult bees. However, their effectiveness was slightly reduced in comparison to previous studies because of mite resistance phenomena. Portions of polyethylene strips of flumethrin from treated hives were sampled weekly to determine acaricide persistence using gas chromatography. After 4 wk, a slight reduction (approximate to9%) of the active ingredient content was observed, A laboratory bioassay also was performed to establish the resistance of adult female mites to fluvalinate, Mites were sampled from the experimental apiary and from various Sardinian apiaries which had primarily been subjected to fluvalinate applications in plastic strips or wood inserts for years. Mite resistance varied from 0 to 96%, depending on the acaricide management adopted, the lowest resistance level occurred in an apiary where pyrethroids had never been used, whereas the highest level occurred in an apiary with intensive use of fluvalinate in wood inserts.